OR-Fab 89000 ORF PRODUCT DISPLAY RACK - Manual (Page 3)

3 DISPLAY RACK #89000
Step 1:
Locate 1 kit top plate (0-03) and 2 kit leg
(0-01).
Use 6 kit 3/8”x 2 1/4” bolts & washers through
both kit top plate (0-03) and 2 kit legs (0-01)
to assemble front side of display “A”-frame.
(Reference arrows for placement.)
Step 2:
Install 6 kit 1” spacers tubes onto inside of kit
3/8” bolts and kit plates.
Locate 1 kit top plate (0-04) and 2 kit legs
(0-02).
Install 2 kit legs (0-02) on top of kit 1” spacer
tubes and through 3/8” bolts; then 1 kit top
plate (0-04) on top of 2 kit legs (0-02).
Use 6 kit 3/8” flange nuts to secure the
upper “A”-frame assembly. (Note: Do not
tighten kit hardware at this time.)
Step 3:
Locate 2 kit caster plate (0-11) for each
“A”-frame leg.
Use 3 kit 3/8”x 2 1/4” bolts, washers and 3 kit
1” spacer tubes through both kit legs (0-01)
& (0-02) to assemble bottom side of display
“A”-frame.
(Reference arrows for placement.)
Repeat process to each leg.
(Note: Do not install bolt or spacer in circled
area at this time. Kit 3/8” nut may be use to
hold assembly together temporarily.)