ARB 3413190 - Manual (Page 4)

29/04/08 Page 4 of 13 3786407
7. On LHS of vehicle secure chassis
bracket and tie down bracket to
vehicle using 14mm x 40 bolts and
spring washers supplied in bolt kit.
(finger tighten only)
8. Using a 13mm drill bit, drill through
chassis rails using hole in impact
absorber as a template. Fit crush
tube, 100mm x10mm bolt, 10mm
washers and nuts through both sides
of chassis brackets. (Finger tighten
only)
9.Fit a 10mm fine thread x 30mm bolt
and washers in the front of chassis
brackets.
10. When all bolts are fitted, the width
of the chassis brackets at bolting
surface should be 860mm. When
measurement is correct, tighten all
bolts securely. Fit 10mm caged nuts
into each chassis bracket. (2 per side)