ARB 3413190 - Manual (Page 8)

29/04/08 Page 8 of 13 3786407
23. Replace the 2 cap screws, washers
and nuts removed in step 19 above into
original holes.
24. Replace the black cover and refit the
three cover screws (DO NOT OVER
TIGHTEN)
25. Fit control box bracket to bar using
8mm hardware.
26. Fit buffers to bull bar using 6mm
hardware.
27. Fit control box to control box
bracket and pull wires through top
cutouts.
28. Fit 8/9000lb winch to top hole
pattern in rear of bar. Secure top
holes of winch using 1 ½” x 3/8”
bolts, spring and flat washers, and
lower holes with 1 ¾” x 3/8’ bolts
through roller fairlead original top
holes. When all bolts are fitted,
tighten firmly.
29. Connect power wires to winch motor
as per Warn instruction manual
(Clutch handle on LHS of
vehicle)