ARB 3413190 - Manual (Page 5)

29/04/08 Page 5 of 13 3786407
TO FIT A WINCH BAR.
11.To fit a 8/9/9.5/000lb winch, rotate
gearbox 144° counterclockwise.
12.Stand winch upright and undo the
capped head screws and by lifting the
gearbox only a couple of millimeters,
rotate the gearbox. Once in position,
refit all screws and tighten firmly.
WARNING
Do not lift gear box more than a couple
of millimeters.
13. To fit a 10/12000 winch, rotate
gearbox 72° clockwise. Both winches
are viewed from gearbox end and
cable spools from the bottom of both
winches.
14. Drill out roller fairlead 25mm
lower than original hole using a
12mm drill bit.
15. 8/9000lb winches use top holes
when fitted to bar
8.
16. 10/12000lb winches use lower holes
when fitted to bar
ORIGINAL
ROTATED
ORIGINAL
ROTATED
VIEWED FROM
LHS OF VEHICLE
VIEWED FROM
RHS OF VEHICLE
New holes