ARB 3413190 - Manual (Page 9)

29/04/08 Page 9 of 13 3786407
30. Fit 10/12000lb winch to lower hole
pattern in rear of bar. Secure top
and lower holes of winch using 1 ½”
x 7/6” bolts, spring and flat washers,
through roller fairlead drilled lower
holes. When all bolts are fitted,
tighten firmly.
31. Connect power wires to winch motor
as per Warn instruction manual.
(clutch handle on RHS of vehicle)
32. When fitting roller fairlead to bar,
remove circlips and push vertical
pins upward so you can push
vertical rollers sideways to enable
you to place a socket to the bolt
33. When all bolts are tighten, replace
pins and circlips.