Assembly sequence for bullbar – ARB 3413050 User Manual
Page 3
03/12/04 Page 3 of 11 3782893
ASSEMBLY SEQUENCE FOR BULLBAR.
1.
1. Remove the bumper bar and grill.
2. Remove the cross member and tow brackets. See
picture.
3. Bend the sheet metal returns located under the light
area down so they don’t interfere when the bar is
fitted. Mask under the light trim and guard and paint
flat black.
4. Bend the center bracket back approx 90 degrees.
2.
1. Insert the tube packers, one in each chassis arm. Line
the bottom of the tube to the bottom hole of the
chassis rail. Rest the top of the tube to the front of the
chassis rail. The tube should be angled forward.
3.
1. Slide the mount assy. over the chassis rails. Try not
to shake the vehicle too severely as the tube packers
may fall out of place.
2. Insert the channel packers from the rear. Make sure
the hole correspond to the holes in the mount.
3. Push the entire mount as far back as possible.