ARB 3413050 - Manual (Page 7)

03/12/04 Page 7 of 11 3782893
ASSEMBLY SEQUENCE FOR BULLBAR.
10. (If fitting with winch)
1. Bolt the roller fair lead to the winch bumper using
the M12 X 40mm bolts, washers, spring washers
and nuts.
11. 1. Fasten the indicator lights to the bar.
2. Position the bar on the mounts and fasten the bar to
the mounts using the M12 X 40mm bolts, large washers
and spring washers.
3. Line up the end of the wing to the wheel arch and
leave approximately a 15mm gap between the bar and
the vehicle. Tighten all bolts.
Note: The lower bolt can be accessed through the cutout
at the front of the wing.
12. (If not fitting winch)
1. Wrap rubber extrusion around winch cover.
2. Place washers over the winch cover fixing holes
located on the top middle face of the winch bumper.
3. Place the winch cover on top of the winch bumper
inline with the mount holes.
4. Bolt together using the M6 button head stainless
steel screws and M6 nuts.