ARB 3413050 - Manual (Page 6)

03/12/04 Page 6 of 11 3782893
ASSEMBLY SEQUENCE FOR BULLBAR.
8.
Viewed from passenger side, gearbox end.
9000lb & H/S 9500lb
Viewed from passenger side, motor end.
10000lb & 12000lb
(If fitting with winch)
To place the clutch handle in a convenient location the
winch gearbox must be rotated.
1. Place the winch on its end and remove all gearbox
bolts.
2. Gently raise the motor just enough to rotate it.
3. Do not completely remove the motor and avoid
damaging the gasket.
4. Refit and tighten all bolts.
Note: Take care not to lift the assembly more than a
couple of millimeters while rotating to the desired
position to avoid unmeshing the gears.
9. (If fitting with winch.)
1. Place the winch on the mount assembly.
2. Bolt from underneath using bolts supplied with
winch and the 3/8” washers supplied in the fitting kit.
Refer to Warn installation instructions for correct
procedure.
Note: If fitting 9000lb or 9500lb high speed winches
mount on the front hole positions. If fitting 10000lb or
12000lb winches mount on the rear hole position.
Fasten the two front bolts first then push the winch to
the back position. Fasten the two rear bolts then tighten
all bolts. Move front lower tie rod to rear lower position
for 10000lb and 12000lb winches.