ARB 3413050 - Manual (Page 5)

03/12/04 Page 5 of 11 3782893
ASSEMBLY SEQUENCE FOR BULLBAR.
7. 1. For pre 09-2002 models use vice grips, multi grips
or pliers bend back the bumper mounting arm
approximately 90 degree’s to clear winch bumper
when assembled.
8. 1. On models built after 09-2002 if you are fitting a
10000lb or 12000lb winch you will need to remove
the upright support and cut a section of it out.
9. 1. Once removed hold the upright in a vice and cut out
the section shown with a hacksaw.
2. Replace the upright and continue fitting the winch.