Preparing bull bar for fitting – ARB 3462040 User Manual
Page 11
Last Rev Date: 24/7/07
Page 10 of 16
Fitting instructions# 3783176
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARING BULL BAR FOR FITTING
18. Screw in the eyebolt after first fitting the
large washer. Eyebolt can be positioned
to sit vertically by rotating the large nut to
the correct position.
NOTE: EYEBOLTS SHOULD BE REMOVED
FOR SAFETY REASONS WHEN
TRAVELLING ON PUBLIC ROADS.
19. When the large nut is in its final
position, secure with the nut retaining
bracket using an M6 bolt, washer and
flange nut.
20. Secure the number plate bracket using
M6 bolts, flat washers and flange nuts.
Attach the longer side to the bullbar and
the shorter side to the number plate.