ARB 3462040 - Manual (Page 6)

Last Rev Date: 24/7/07 Page 5 of 16 Fitting instructions# 3783176
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING MOUNTING BRACKETS
1. Remove plastic shroud above radiator as
shown, by releasing plastic clips
2. To remove the grille, carefully push the
retainer spring clips back out in four
places behind grille. Pull outer bar from
between headlights forward to release
from clip into end of guard.
NOTE: It may be necessary to remove top
headlights to gain access to these clips if
you cannot release them easily.
3. If fog lamps are fitted to bumper, undo
electrical connections.
4. Remove bumper by undoing four bolts
from above and behind bumper then two
bolts securing bumper to wing support
braces from under and behind forward of
wheel arch area.