Preparing bull bar for fitting – ARB 3462040 User Manual
Page 40
Last Rev Date: 24/07/07
Page 9 of 14
Fitting instructions# 3783178
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARING BULL BAR FOR FITTING
20. Screw in the eyebolt using the large
washer. Eyebolt can be positioned to sit
vertically by rotating the large nut to the
correct position.
NOTE: EYEBOLTS SHOULD BE
REMOVED FOR SAFETY REASONS
WHEN TRAVELLING ON PUBLIC
ROADS
.
21. When the large nut is in its final position,
secure with the nut retaining bracket using
an M6 bolt, washer and flange nut.
22. Secure the number plate bracket using
M6 bolts, flat washers and flange nuts.
Attach the longer side to the bullbar and the
shorter side to the number plate.