ARB 3462020 - Manual (Page 21)

11/10/05 Page 7 of 14 3783176
1.10 Fit M12 cage nuts to both bent plates, 1 x
LH and 1 x RH as assemblies are
opposite for each side of vehicle. Insert
nut assembly through large hole in
underside of chassis and up to meet
vacant hole above long bolt. Insert M12
bolt and washer set, do up finger tight.
1.14 Check that brackets are parallel to each
other, if not adjust. When parallel then
tighten all bolts (nominal outside
dimension across brackets is 898mm).
Fit grille and shroud back into
position.