ARB 3462020 - Manual (Page 46)

11/10/05 Page 4 of 13 3783177
ASSEMBLY SEQUENCE FOR WINCH BUMPER.
1. FITTING MOUNTING BRACKETS
1.1 Remove plastic shroud above radiator as
shown, by releasing plastic clips
1.2 To remove the grille, carefully push the
retainer spring clips back out in four
places behind grille. Pull outer bar from
between headlights forward to release
from clip into end of guard. NOTE: It may
be necessary to remove top headlights to
gain access to these clips if you cannot
release them easily
1.3 Remove bumper by undoing four bolts
from above and behind bumper then two
bolts securing bumper to wing support
braces from under and behind forward of
wheel arch area.