Hornady Lock-N-Load Ammo Plant - Manual (Page 20)

¼-20 x 1 ½" Cap Screw (Full Size)
¼-20 x 1 ½" Cap Screw (Full Size)
Case Escapement Backet Assembly.
Put a ¼" Flat Washer on the ¼-20 X 1 ½" Cap Screw (70).
Place the Cap Screw through the Square Tubing and thread
the Hex Nut the length of the nut.
Slip the Pivot Block (29) over the Cap Screw (70) so
the Hex Nut is in the slot on the back of the Case
Escapement Body.
Slip the Cam Wire (43) into the Cam Wire Support (31).
Tighten the Cap Screw while holding the Bracket level
with the top of the frame.
Feed Tube Mounting Bracket.
Slide the 1” Square Tube Connector (75) into the tubing (76)
with the open end of the V forward until the bottom hole lines
up with the uppermost hole in the tubing. Orient the Feed
Tube Mounting Bracket (16) as shown in the exploded view.
Place a ¼-20 x 1.50 SHCS (70) through the bottom hole, then
through the square tubing. Place a ¼ Flat Washer (48) and
¼ Lock Washer (49) over the screw, and lightly thread on a
¼-20 Hex Head Nut (26).
Slide the Case Feeder Stand 2-PC Upper tube (74) over the
Square Tube Connector (oriented as shown in the exploded
view) until the two holes line up. Place a ¼-20 SHCS through
the remaining hole in the Feed Tube Mounting Bracket and
through the square tubing. Place a ¼ Flat Washer and ¼
Lock Washer over the screw, and thread on a ¼-20 Hex Head
Nut. Tighten both Hex Head Nuts until snug.
5
6
7
5
6
7
Cam Wire
Support
Pivot Block
Feed Tube
Mounting
Bracket
Cap Screw
Cam Wire
Cap Screw
Flat Washer
Hex Nut
Hex Nut
Cap Screw
- 20 -
ASSEMBL
Y
ASSEMBLY: CASE FEEDER