Hornady Lock-N-Load Ammo Plant - Manual (Page 33)

Insert the Drop Funnel (5) into Tube Spring Clamp (3). You
will want the front edge (outside edge) of the Drop Funnel
as close to the Bullet Feed Wheel Pistol without touching the
Bullet Feed Wheel Pistol.
Tighten the Knurled Thumb Screw (2) on the side of the Tube
Spring Clamp. Only snug this screw,
DO NOT over tighten
this screw.
Install the wipers as shown in with one Wing Nut installed on
the outside of the Bullet Feed Hopper) on the Wiper Screw.
Place one bullet facing the center of the Bullet Feed Wheel
Pistol base first. Next to it, place a bullet facing nose first
to the center of Bullet Feed Wheel Pistol. The bullet that is
facing nose first, push the nose down a little so the base
is sticking up.
Adjust the second Wiper Spring and Wiper Screw to just
miss the nose of the first bullet but kick the base of the
second bullet.
Tighten down the two Wing Nuts and the Thumb Screw.
Select the correct size of Drop Funnel for your application.
9MM/38/.357 ...........(375 I.D.) ............Item No. 399216
40 S&W/10 MM ........(406 I.D.) ............Item No. 399215
.44/.451/.452 ............(530 I.D.) ............Item No. 399214
Drop Funnel
This completes the basic assembly of the
Ammo Plant.
Continue to the Changeover/Setup Section
for detailed instructions on how to setup
the Ammo Plant for a specific cartridge.
Bullet Wiper (Top Wiper)
Wiper Screw Thumb Screw
Wiper Spring
Drop Funnel
Wing Nuts
13
14
15
13
14
15
Tube Spring
Clamp
Bullet Feed
Wheel Pistol
Knurled Thumb
Screw
ASSEMBL
Y
- 33 - ASSEMBLY: PISTOL BULLET FEEDER