Hornady Lock-N-Load Ammo Plant - Manual (Page 22)

Set the Pivot (19) on top of the Pivot Block (29). Make sure
you line up the under cut in the bottom of the pivot with the
Torsion Spring (23). The leg of the Torsion Spring will fit into
the slot on the Pivot.
When this fits together, the Pivot should fit on top of the Pivot
Block. The Dowel Pin (21) in the Pivot will fit into the curved
slot on the Pivot Block (29).
Then insert the Shoulder Bolt (20) into the pivot and into the
pivot block and tighten with an Allen wrench.
Actuate the Pivot by hand to make sure it will rotate
smoothly and spring return back under the Feed Tube.
For small rifle cases, place the Pivot Adapter Bushing into the
hole of the Pivot Adapter
.
11
12
13
11
12
13
Pivot Adapter
Bushing
Shoulder
Bolt
Pivot
Pivot
Assembling the Feed Tube End
and Pivot (con't).
- 22 -
ASSEMBL
Y
ASSEMBLY: CASE FEEDER