Hornady Lock-N-Load Ammo Plant - Manual (Page 21)

Installing the V-Block onto the
case slide.
With the Ram at the bottom of the stroke (idle position), set the
V-Block onto the Case Slide (38).
Refer to chart on page 45 for proper V-Block.
Place the #10-24 X 1/2 Cap Screw (59) through the hole of the
V-Block and screw it into the Case Slide. Before you tighten the
Cap Screw, push the V-Block back into the Case Slide and snug
the Cap Screw with your fingers.
The proper adjustments of the cam wire will be discussed later
on
Change-Over: Case Feeder Page 46.
Assembling the Feed Tube End
and Pivot.
If the maximum case diameter is larger than .43" you will
need to use the large Drop Tube. If it is smaller, you will need
the small Drop Tube. Place the correct one into the Pivot Block.
10
9
8
8
9
10
Torsion Spring
Drop Tube
Pivot Block
V-Block
Cap Screw
Place the Torsion Spring (23) into the slot in the Pivot
Block (29), leaving the long leg on the top side. The Spring
will only fit one way.
ASSEMBL
Y
- 21 - ASSEMBLY: CASE FEEDER