Hornady Lock-N-Load Ammo Plant - Manual (Page 32)

Install the wipers as with one Wing Nut (25) installed on the
outside of the Bullet Feed Hopper on the Wiper Screw (24).
Loosen the wing nuts.
Place two bullets nose to nose in a slot close to the height
of the first or bottom wiper screw and Wiper Spring (26).
Adjust the first wiper spring and screw to wipe off the
outside bullet.
Tighten down the two wing nuts and the thumb screw.
Bullet Wiper (Bottom Wiper)
Raise the Hopper Turning Plate (11) by turning the
Adjustment Screw (6) clockwise.
Raise the Bullet Guide Plate above the bottom of the slots
on the Bullet Feed Wheel Pistol far enough to hold a bullet
base first against the Bullet Feed Wheel Pistol.
Place a bullet that you plan on loading facing base first up
against the Bullet Guide Plate and against the Bullet Feed
Wheel Pistol. Next to this bullet, place another bullet so that
the nose is facing the center of the Bullet Feed Wheel Pistol.
You will then need to adjust the Bullet Guide Plate either
up or down to get a bullet to stay on the Bullet Feed Wheel
Pistol base first, but fall off the Bullet Feed Wheel Pistol
if the bullet is nose first towards center of the Bullet Feed
Wheel Pistol.
Bullet Feed Hopper Set Up (con't)
Wiper Screw
Hopper
Wing Nuts
Wiper Spring
10
11
12
10
11
12
Adjustment
Screw
Hopper Turning
Plate
Bullet Guide
Plate
Bullet Feed
Wheel Pistol
- 32 -
ASSEMBL
Y
ASSEMBLY: PISTOL BULLET FEEDER