Hornady Lock-N-Load Ammo Plant - Manual (Page 7)

Mounting the Lock-N-Load ®
Auto Progressive
Your work area should be well lit and have plenty of room for
your reloading accessories. Your Hornady Lock-N-Load
® AP ™
should be mounted securely 2 1/4" from the edge of a solid level
bench and 3.75" apart and at least 16" from the nearest wall.
Use the template found on the last page and a hole punch to
help locate each hole. (Check for obstructions on or below the
bench before you drill any holes.)
Place cartridge catcher bracket under press, line up holes in press
with holes in bracket.Insert and firmly tighten both bolts.
Mount the press using two 5/16" bolts that are long enough to
secure the press to the bench with plenty of clearance for the
nuts. (Due to variation of benches, these bolts are not provided.)
We also recommend using 5/16" flat washers top and bottom, in
addition to lock washers on the bottom side.
Insert and firmly tighten both bolts.
Thread the press Handle into the Toggle at the bottom of the press
and tighten the Jam Nut using a 15/16" wrench.
1
2
3
1
2
3
Handle
Jam Nut
Toggle
ASSEMBL
Y
- 7 - ASSEMBLY: AP PRESS