Hornady Lock-N-Load Ammo Plant - Manual (Page 44)

8
9
10
8
9
10
Place an empty, primed case into the station of the shell
plate that will rotate to the powder measure. Raise the ram
which will cycle the powder measure to the top of its stroke.
Thread the bottom cap screw in until the threaded end
bottoms out on the lower hex spring mount.
Lower the ram and replace the vertical spring on the
hex spring mount.
To adjust for more case mouth flare, continue to screw in
the bottom cap screw, for less case mouth flare, back it out.
Make small adjustments.
When adjusted as desired, tighten jam nuts to lock in
adjustment.
- 44 - CHANGE-OVER: POWDER MEASURE
CHANGE-OVER