AEM 30-3812 Infinity Plug & Play Harnesses - Ford Coyote to Ford Racing Controls Pack - Manual (Page 17)

Ford Coyote 5.0L V8 17
© 2014 AEM Performance Electronics
C2-32 AGND_2
Ford
Racing
PCM70 -
44 &
PCM70 -
60
APP Sensor 1 & 2
Ground
APPRTN (1) & (2)
Dedicated analog ground Analog 0-5V sensor ground
C2-33 Analog_In_20
Ford
Racing
PCM50 -
19
Clutch Position
(Neutral Switch)
Blunt Lead
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU. 'See ClutchSwitch 1-axis table
for setup options. Input can be
assigned to different pins. See Setup
Wizard page 'Input Function
Assignments' for input mapping
options.
C2-34 Analog_In_21 ---
3 Step Enable
Switch / TPS2A
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU. See 3StepSwitch 1-axis table for
setup.
C2-35 Analog_In_22 --- USB Logging Activate
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU. See USBLoggingRequestIn
channel for input state. See Setup
Wizard page 'USB Logging' for
configuration options.
C2-36 Analog_In_23 ---
Charge Out
Pressure / TPS2B
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU. See ChargeOutPress [kPa]
channel for input state. See Setup
Wizard page 'Charge Out Pressure'
for calibration options.
C2-37 Digital_In_6 --- Spare Digital Input
No pullup. Will work with
TTL signals.
Input can be assigned to different
pins. See Setup Wizard page Input
Function Assignments for input
mapping options.
C2-38 Digital_In_7 --- Brake Switch
No pullup. Will work with
TTL signals.
See BrakeSwitch 1-axis table for
setup options. Input can be assigned
to different pins. See Setup Wizard
page 'Input Function Assignments' for
input mapping options.
C2-39 Power Ground --- Ground Power Ground Connect directly to battery ground
C2-40 Power Ground --- Ground Power Ground Connect directly to battery ground
C2-41
CanH_Bout --- CANH
Dedicated High Speed
CAN Transceiver
Not used
C2-42
CanL_Bout --- CANL
Dedicated High Speed
CAN Transceiver
Not used