Apple Motion 2 - Manual (Page 679)

Chapter 9 Using the Replicator 679
8 Set the Angle value to 240 degrees and the Scale value to 80 percent.
9 Deselect the object (click in a gray area of the Canvas) and play the project (press the
Space bar).
The replicator elements rotate and increase in size over time to create a pinwheel.
Tip: A simple way to create a new look for a replicator is to move the position of the
source object’s anchor point. You can continue to play the project while you adjust the
anchor point until you create a look that you like.
To change the anchor point of a replicator source object:
1 In the Layers tab, select the source object. Although not required to adjust its anchor
point, you can enable the source object so you can see it in the Canvas.
2 In the Toolbar, select the Adjust Anchor Point tool.
Note: You can also press Tab to cycle through the onscreen control modes.
Adjust Anchor Point tool
01112.book Page 679 Sunday, March 13, 2005 10:36 PM