Lull 1044C-54 Series II Operation Manual - Manual (Page 124)

Section 7 - Lubrication and Maintenance
7-14 31200608
Engine Oil
A. Engine Oil Level Check
1. Perform “Shut-Down Procedure” on page 4-4.
2. If equipped, open engine access door.
3. Remove dipstick (1) and check oil mark. The oil should be between the full (2)
and add (3) marks within the crosshatched area of the dipstick.
4. If oil is low, remove oil fill cap (4) and add motor oil to bring oil up to the full mark
in the crosshatch area.
5. Replace oil fill cap and dipstick.
6. If equipped, close and secure engine access door.
Note: The standard service interval for engine oil and filter is 250 hours maximum.
If an extended service interval is desired, see your engine manual for specific
guidelines for optimizing oil change intervals.
10
OW0970
OW1020
OV0551
4
1
1
2
3
4
CUMMINS ENGINE JOHN DEERE ENGINE