Lull 1044C-54 Series II Operation Manual - Manual (Page 41)

Section 3 - Controls and Indicators
3-7 31200608
Park Brake
Park brake knob (1) controls the application and release of the park brake.
• Pull knob out to engage park brake. Push knob in to disengage park brake.
• With the engine running and the park brake knob pushed in, park brakes are
disengaged.
• With knob pulled out, park brake is engaged and transmission will not engage
forward or reverse.
Parking Procedure
1. Using service brake, stop telehandler in an appropriate parking area.
2. Follow “Shut-Down Procedure” on page 4-4.
WARNING
MACHINE ROLL-AWAY HAZARD. Always pull park brake knob out, lower boom
to ground and stop engine before leaving cab.
WARNING
CRUSH HAZARD. Turning engine off applies the park brake. Applying park brake
or turning engine off while traveling will cause unit to stop abruptly and could
cause load loss. Either may be used in an emergency situation.
OV0150
1