Lull 944E-42 Service Manual - Manual (Page 248)

Transfer Carriage
11-8 944E-42
14. Coat the capscrew with Loctite
®
242 (blue). Replace
the hydraulic tubes (15) and mounting bracket with
capscrew. Torque the hydraulic tubes (15) to the
hydraulic junction manifold (16) to 45 - 59 lb-ft (61 -
80 Nm).
15. Replace the slave cylinder hydraulic hoses (17)
according to their previously labeled positions.
Torque the connections at the slave cylinder to,
50 - 60 lb-ft (67 - 81 Nm). Torque the connection at
the hydraulic tubes to, 45 - 59 lb-ft (61 - 80 Nm).
16. Lift and place the lift/lower cylinder (1) into position
on the transfer carriage (2). Coat the capscrew with
Loctite
®
242 (blue). Insert pin (3) and secure it with
capscrew and washer. Torque capscrew to, 43 - 78
lb-ft (59 - 106 Nm).
17. Replace the larger hydraulic hose (4) and smaller
hydraulic hose (5) connecting the lift cylinder (1) to
the hydraulic junction manifold (6). Route the hoses
under and then up through the hole in the transfer
carriage. Torque the larger hose (4) to,
100 - 140 lb-ft (135 - 190 Nm). Torque the smaller
hose (5) to, 45 - 59 lb-ft (61 - 80 Nm).
MU1701
13
14
15
16
17
MU1692
1
2
3
4
5
6