sPOD FJ - Manual (Page 4)

s POD Installation Instructions
Toyota FJ Cruiser
www.4x4s-POD.com
4
After installation
!!!Must start engine to activate system!!!
16. Connect the red wire to the
positive side of the battery
.
1. Attach your accessories here.
SWx Is the
Positive and GND is the negative terminals.
2. Negative battery terminal.
3. Positive battery terminal.
4. Switch panel harness input.
5. Switch panel fuse.
6. Low voltage detection circuit.
7. Low voltage detection circuit fuse. Remove this fuse to
disable LVCO
• If the LVCO detects a low voltage (10.6VDC) and
shuts the sPOD down, turn off all switches on sPOD
and start the vehicle to enable the sPOD again.
8. Accessory fuses. Any fuse can go here up to 30 AMPs. (6 pl.)
9. Relays that are removable.
Always keep your engine running
whenever possible when powering
electrical accessories
2
3
9
1
7
4
6
8
5