sPOD TJ 1997-2002 Instructions over battery - Manual (Page 3)

s POD Installation Instructions
1997 – 2002 Wrangler
3
Send wire harness and
terminals down through here.
Drill 1 in. diameter hole here on
passenger side under glove box area.
• Use supplied cable ties to tie down harness as required. Trim ends after all ties are cinched down snugly.
• Remove glove box and feed wire harness down behind glove box and out of the way for now.
• Now drill a 1” dia. hole where shown from inside of the Jeep below the glove box area.
• Install supplied grommet and feed connectors through the firewall into the engine compartment.
• Re-install the battery.
• Next remove the 4 counter sunk screws from the plastic to the bracket and slide the assembly off the bracket
before installing the Source mounting plate.
• Remove the 2 #10 screws using a 5/16” socket located on ECU just above the battery.
Grommet Pull carpet back
Use the 2 supplied #10 x 2”
long Philips head sheet
metal screws with washers
to attach Source mounting
plate to the ECU
5/16” #10 sheet metal screws
Counter sunk
screws
Re-install the Source back on to the plate.
Do not over tighten
4 counter sunk screws!