IKA HBC 10 control - Manual (Page 29)

29
EC Declaration of Conformity
Explication of warning symbols
DANGER
General hazard
This symbol identifies information that is of vital importance for protecting your health
and safety. Disregarding this information may lead to health impairment and injuries.
This symbol identifies information that is of importance for the technically correct func-
tioning of the system. Disregarding this information may result in damage to the instrument
or to system components.
This symbol indicates information which is important for proper use and ensuring that the
operations of the instrument are performed efficiently. Failure to observe this informa-
tion may result in inaccurate results.
Danger - Reference to exposure to a hot surface!
Hot surface!
DANGER
CAUTION
WARNING
We declare under our sole responsibility that this product corresponds to the regulations 2006/95/EC, 2004/108/EC,
1999/5/EC and 2011/65/EU and conforms with the standards or standardized documents: EN 61010-1, -2-010, -2-051;
EN 61326-1 and DIN 12876-1.
Bluetooth
® module:
Directive: 1999/5/EC Standards: EN 60950-1, EN 300328, EN 301489-17
Note for USA (FCC)
This equipment complies with Part 15 of the FCC rules. Any changes or modifications not expressly approved by the
Manufacturer could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC
rules subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept all interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equip-
ment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
Note for Canada (IC)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with Health Canada’s Safety Code 6/IC RSS-210. The installer of this device should ensure that RF radiation
is not emitted in excess of the Health Canada’s requirement.