Eppendorf Mastercycler pro - Manual (Page 52)

PCR run
Mastercycler pro
English (EN)
52
7.2.1 Status view
The status view is automatically displayed immediately after a program is started. It shows the progress of
and information on a running program. The currently active step is displayed as a flashing line.
You can exit the status view at any time via the Exit function key to return to the navigation tree and, for
example, edit another program or start a program on a different cycler. The program that was already
started is not interrupted as a result.
7.2.1.1 Displaying the status view
Proceed as follows:
1. Mark the cycler in the navigation tree.
2. Press the Status function key.
1 Program path and cycler
2 Remaining runtime
3 Start and end time of the program
4 Block and heated lid temperature
5 Device status
6 Cycle number
7 Block target temperature
8 Remaining hold time
9 Information on the current program step
If you have activated the TSP/ESP function in the program header (see p. 42), the heated lid is
heated or cooled to the desired temperature before the program run starts. This process is
indicated in the status view by the message
TSP Heated Lid .
The cycler is indicated in the navigation tree with a green symbol while it executes a
program.
1
2
3
4
5
6
7
8
9