Eppendorf Mastercycler pro - Manual (Page 80)

Transport, storage and disposal
Mastercycler pro
English (EN)
80
Proceed as follows:
1. Pay attention to the decontamination notes (see Decontamination before shipment on p. 76).
2. Switch off the device and open the heated lid.
3. Let the device stand for 30 minutes and ensure that there is no condensate in the thermoblock.
4. Disconnect the device from the power supply.
5. Disconnect all the connections from the rear of the device and remove the control panel.
6. Load the thermoblock with an empty PCR plate.
7. Close the heated lid.
8. Pack the device into the plastic bag.
9. Place the foam bottom part onto the bottom of the packaging.
10. Hold the device at the front and back of the lower part of the housing and lift it into the foam bottom
part.
11. Place the foam lid on top of the device.
12. Close the carton lid and insert the four plastic locking clips into the cut-outs on the side of the carton.
13. For fastening, push in the flaps of the plastic locking clips.
12.2 Transport
 Use only the original packaging for transport.
The transport and storage conditions are described separately(see Ambient conditions on p. 83).