JLG 800A_AJ Operator Manual - Manual (Page 80)

SECTION 4 - MACHINE OPERATION
4-16 – JLG Lift – 3121627
4.9 OSCILLATING AXLE LOCKOUT TEST (IF EQUIPPED)
LOCKOUT SYSTEM TEST MUST BE PERFORMED QUARTERLY, ANY TIME A SYSTEM COM-
PONENT IS REPLACED, OR WHEN IMPROPER SYSTEM OPERATION IS SUSPECTED.
Refer to Section 2.4, Oscillating Axle Lockout Test (If Equipped) for
procedure.
4.10 TOWING
The machine is not equipped with a tow package. Refer to Sec-
tion 5 for emergency towing procedures.
4.11 TOW BAR (IF EQUIPPED)
RUNAWAY VEHICLE/MACHINE HAZARD. MACHINE HAS NO TOWING BRAKES. TOWING
VEHICLE MUST BE ABLE TO CONTROL MACHINE AT ALL TIMES. ON-HIGHWAY TOWING
NOT PERMITTED. FAILURE TO FOLLOW INSTRUCTIONS COULD CAUSE SERIOUS INJURY
OR DEATH.
MAXIMUM TOWING SPEED 5 M.P.H. (8 K.M.H.)
MAXIMUM TOWING GRADE 25%.
Prior to towing the machine, complete the following:
DO NOT TOW MACHINE WITH ENGINE OPERATING OR DRIVE HUBS ENGAGED.
1. Retract, lower and position boom in travel position; lock
turntable.
2. Lower tow bar and connect to towing vehicle
3. Disconnect drive hubs by inverting disconnect cap.