JLG M450 ANSI Service Manual - Manual (Page 128)

SECTION 4 - BOOM & PLATFORM
4-16 – JLG Lift – 3121127
Disassembly
1. Remove the cap screws (113) over end cap lock
pins (109).
2. Using a 1/8” (3.18mm) drill bit, drill a hole in the cen-
ter of each lock pin to a depth of approximately 3/
16” (4.76mm).
3. Remove the lock pins using an “Easy Out” (a size
#2 is shown). If the pin will not come out with the
“Easy Out”, use 5/16” drill bit to a depth of 1/2”
(12.7mm)todrill out the entire pin.
4. Install the end cap (4) removal tools provided with
the Helac seal kit.
5. Using a metal bar, or something similar, un-screw
the end cap (4) by turning it counter clock-wise.
6. Remove the end cap (4) and set aside for later
inspection.