JLG M450 ANSI Service Manual - Manual (Page 186)

SECTION 6 - JLG CONTROL SYSTEM
6-8 – JLG Lift – 3121127
J2
1 CONT MAIN CONTACTOR DIGITAL OUTPUT
2 FWD DRIVE FORWARD DIGITAL OUTPUT
3 REV DRIVE REVERSE DIGITAL OUTPUT
4 N/C NOT CONNECTED GROUND INPUT
5 GND GROUND GROUND INPUT
6 N/C NOT CONNECTED GROUND INPUT
J3
1 IGN SPEED ENCODER POWER +12V OUTPUT
2 SPD SPEED ENCODER SIGNAL DIGITAL INPUT
3 GND SPEED ENCODER GROUND GROUND INPUT
4 DIR SPEED ENCODER DIRECTION DIGITAL INPUT
5 N/C NOT CONNECTED N/C N/C
6 N/C NOT CONNECTED N/C N/C
J4
1 N/C NOT CONNECTED DIGITAL INPUT
2 N/C NOT CONNECTED +12V OUTPUT
J5
1 N/C NOT CONNECTED DIGITAL INPUT
2 N/C NOT CONNECTED +12V OUTPUT
LED
PIN 1
1600302-F
Figure 6-4. Power Controller - Sheet 3 of 4