JLG M450 ANSI Service Manual - Manual (Page 150)

SECTION 4 - BOOM & PLATFORM
4-38 – JLG Lift – 3121127
Replacing Moving End Brackets
1. Remove existing pins and center rivet. Remove the
rivet the same way as shown in the link removal
instructions. Repeat on other bracket if replacing it
as well.
MOVE THE CABLES/HOSES OUT OF THE WAY DURING THE
GRINDING PROCESS TO PROTECT THEM. KEEP THE HOSES AND
CABLES COVERED TO PREVENT ANY DEBRIS FROM GETTING ON
THEM.
2. Take new bracket and install center pin with snap
ring.