JLG M450 ANSI Service Manual - Manual (Page 179)

SECTION 6 - JLG CONTROL SYSTEM
3121127 – JLG Lift – 6-1
SECTION 6. JLG CONTROL SYSTEM
6.1 JLG CONTROL SYSTEM ANALYZER KIT
INSTRUCTIONS
Introduction
WHEN INSTALLING A NEW POWER MODULE CONTROLLER ON
THE MACHINE, IT WILL BE NECESSARY TO PROGRAM THE CON-
TROLLER FOR THE PROPER MACHINE CONFIGURATION, INCLUD-
ING OPTIONS.
IT IS A GOOD PRACTICE TO AVOID PRESSURE-WASHING ELEC-
TRICAL/ELECTRONIC COMPONENTS. SHOULD PRESSURE-
WASHING BE UTILIZED TO WASH AREAS CONTAINING ELECTRI-
CAL/ELECTRONIC COMPONENTS, JLG INDUSTRIES, INC. REC-
OMMENDS A MAXIMUM PRESSURE OF 750 PSI (52 BAR) AT A
MINIMUM DISTANCE OF 12 INCHES (30.5 CM) AWAY FROM
THESE COMPONENTS. IF ELECTRICAL/ELECTRONIC COMPO-
NENTS ARE SPRAYED, SPRAYING MUST NOT BE DIRECT AND BE
FOR BRIEF TIME PERIODS TO AVOID HEAVY SATURATION.
Figure 6-1. Control Module Location