JLG 150HAX Operator Manual - Manual (Page 104)

SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-26 – JLG Lift – 3121213
2. Tighten nuts in the following sequence:
3. The tightening of the nuts should be done in stages. Fol-
lowing the recommended sequence, tighten nuts per
wheel torque chart.
4. Wheel nuts should be torqued after first 50 hours of
operation and after each wheel removal. Check torque
every 3 months or 150 hours of operation.
6.5 SUPPLEMENTAL INFORMATION
The following information is provided in accordance with the
requirements of the European Machinery Directive 2006/42/
EC and is only applicable to CE machines.
For electric powered machines, the equivalent continuous A-
Weighted sound pressure level at the work platform is less
than 70dB(A)
For combustion engine powered machines, guaranteed
Sound Power Level (LWA) per European Directive 2000/14/
EC (Noise Emission in the Environment by Equipment for
Use Outdoors) based on test methods in accordance with
Annex III, Part B, Method 1 and 0 of the directive, is 112 dB.
The vibration total value to which the hand-arm system is
subjected does not exceed 2,5 m/s 2 . The highest root mean
square value of weighted acceleration to which the whole
body is subjected does not exceed 0,5 m/s 2 .
Table 6-14. Wheel Torque Chart
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
70 ft. lbs.
(95 Nm)
170 ft. lbs.
(225 Nm)
300 ft. lbs.
(405 Nm)