JLG 150HAX Operator Manual - Manual (Page 27)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3121213 – JLG Lift – 2-7
GENERAL
Begin the "Walk-Around Inspection" at Item 1, as noted on the
diagram. Continue to the right (counterclockwise viewed from
top) checking each item in sequence for the conditions listed
in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN
CORRECTED.
INSPECTION NOTE: On all components, make sure there are
no loose or missing parts, that they are securely fastened, and
no visible damage, leaks or excessive wear exists in addition
to any other criteria mentioned.
1. Rear Frame Deck - Deck clean and free of grease
and oil; deck treads in place and undamaged.
2. Platform Access Ladder - See Inspection Note.
3. Axle Jack/Extension Switches - See Inspection
Note; decals in place and legible.
4. All Hydraulic Cylinders - No visible damage; pivot
pins and hydraulic hoses undamaged, not leaking.
5. Tie Rods and Steering Linkage - No loose, bent, or
missing parts; no visible damage; tie rod ends
undamaged.
6. Platform Assembly - See Inspection Note. Foot-
switch in good working order; not modified, disabled,
or blocked. Gate interlock functioning properly. Inter-
com properly secured and operating.
7. Platform Control Console - Switches and controllers
properly secured; no loose or missing parts; informa-
tion and operating placards are in place and legible;
controllers and switches return to neutral; control
markings legible. Capacity indicator properly secured;
no visible damage; operating properly.
8. Extendable Axle - See Inspection Note. Power track
and hydraulic hoses secure and undamaged; no evi-
dence of leakage.
Figure 2-2. Daily Walk-Around Inspection - Sheet 2 of 4