JLG 80SL Operator Manual - Manual (Page 86)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-14 – JLG Lift – 3121324
Tire Replacement
JLG recommends a replacement tire be the same size, ply
and brand as originally installed on the machine. Please refer
to the JLG Parts Manual for the part number of the approved
tires for a particular machine and model. If not using a JLG
approved replacement tire, it is recommended that replace-
ment tires have the following characteristics:
• Equal or greater ply/load rating and size of original.
• Tire tread contact width equal or greater than original.
• Wheel diameter, width, and offset dimensions equal to
the original.
Unless specifically approved by JLG Industries, Inc. do not
replace a foam filled tire assembly with a pneumatic tire.
When selecting and installing a replacement tire, ensure that
all tires are inflated to the pressure recommended by JLG.
Due to size variations between tire brands, both tires on the
same axle should be the same.
Wheel Replacement
The rims installed on each product model have been
designed for stability requirements which consist of track
width, tire pressure, and load capacity. Size changes such as
rim width, center piece location, larger or smaller diameter,
etc., without written factory recommendations, may result in
an unsafe condition regarding stability.