JLG 600A_AJ Operator Manual - Manual (Page 60)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-16 – JLG Lift – 3121615
Platform Control Indicator Panel
(See Figure 3-5., Platform Control Indicator Panel)
1. Tilt Alarm Warning Light and Alarm
This illuminator indicates that the chassis is on
a slope. An alarm will also sound when the
chassis is on a slope and the boom is above
horizontal. If lit when boom is raised or extended, retract
and lower to below horizontal then reposition machine so
that it is level before continuing operation. If the boom is
above horizontal and the machine is on a slope, the tilt
alarm warning light will illuminate and an alarm will sound
and CREEP is automatically activated.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED,
RETRACT AND LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS LEVEL BEFORE EXTENDING BOOM OR RAISING BOOM ABOVE HORIZONTAL.
NOTE: When the tilt sensor alarm is activated the Drive function will be
disabled if the boom is elevated above horizontal.
2. Platform Overload (If equipped)
Indicates the platform has been overloaded.
3. Capacity Indicator
Indicates the maximum platform capacity for
the current position of the platform.
Restricted capacities are permitted at
restricted platform positions (shorter boom
lengths and higher boom angles).
NOTE: Refer to the capacity decals on the machine for
restricted and unrestricted platform capacities.