1 introduction—cummins, 1 disclaimer and scope, 2 engine serial number – JLG G6-42A Service Manual User Manual
Page 114: 3 specifications and maintenance information, 4 component terminology, Introduction—cummins, Disclaimer and scope, Engine serial number, Specifications and maintenance information, Component terminology
Engine
7-2
G6-42A, G9-43A, G10-43A
7.1
INTRODUCTION—CUMMINS
7.1.1
Disclaimer and Scope
These instructions are written for worldwide use. In
territories where legal requirements govern engine smoke
emission, noise, safety factors, etc., apply all instructions,
data and dimensions provided herein in such a way that
after maintenance, service and repair of the engine,
engine operation does not violate local regulations.
Note: Detailed engine service instructions (covering
disassembly, inspection, internal repair, assembly,
adjustment and troubleshooting information) are
provided in appropriate engine service manual.
A gradual running-in (break-in) of a new engine is not
necessary. Full load can be applied to a new engine as
soon as the engine is put into service and the coolant
temperature is at least 140° F (60° C). Extended light-
load operation during the early life of the engine is not
recommended. DO NOT run the engine at high, no-load
speeds. DO NOT apply an overload to the engine.
7.1.2
Engine Serial Number
The engine serial number Is stamped on top of engine.
Information contained in serial number is required in
correspondence with engine manufacturer.
7.1.3
Specifications and Maintenance
Information
For engine, coolant and oil specifications, and
maintenance information, refer to Section 2, “General
Information and Specifications.”
Note: Refer to Section 9.13.1, “Gauge Fault Code
Display” for error codes and troubleshooting.
7.1.4
Component Terminology
To understand safety, operation and maintenance
information presented in this section, it is necessary that
operator/mechanic be familiar with names and locations
of engine components. The following illustration identifies
components that are referred to throughout this section.
WARNING
DO NOT service the machine without following all safety
precautions as outlined in Section 1, “Safety Practices,” of
this manual
WARNING
Engine fuel lines are pressurized. DO NOT attempt repairs
unless specific training has been completed.