JLG LSS Scissors - Manual (Page 21)

SECTION 2 - OPERATION - (LE, MRT, RTS)
3124288 – JLG Lift – 2-9
2.7 JLG WORKSTATION IN THE SKY™
ACCESSORIES
The Load Sensing System must be configured for proper
operation with JLG Sky™ Accessories. Calibration of the
Load Sensing System can be performed with the Acces-
sory mounted in the platform.
A platform-mounted accessory slightly reduces the
amount of load that can be carried before the vehicle
becomes overloaded. This extra load must be accounted
for to enable the accessory to be mounted during Calibra-
tion.
A De-Rating is provided for JLG Sky Accessories via decal
and/or the JLG Workstation in the Sky
TM Accessory Man-
ual. This De-Rating must be entered into the LSS Mod-
ule’s ACC’Y Personality to cause the system to accurately
indicate overload (by the De-Rating factor).
Example: Consider that of the Easi-Cladder™ with a De-
Rating of 300 lbs (136 kg) mounted on a 500RTS. Without
De-Rating, the Load Sensing System will declare on Over-
load at 2750 lb (1247 kg), which is 110% of its 2500 lb
(1134 kg) rated Load. When the De-Rating for Easi-Clad-
der™ is entered into the ACC’Y Personality, the LSS will
declare Overload 300 lb (136 kg) earlier (2450 lb or 1111
kg).
Procedurally, the Accessory should be mounted to the
platform and the LSS Module’s ACC’Y Personality should
be set using the guidelines above. Calibration should be
performed as outlined in this manual. During Testing &
Evaluation, it should be noted that the LSS will declare
Overload with less platform load (by the amount of the De-
Rating).
Table 2-6. LSS Module Guidelines
PERSONALITY SETTING
ACC’Y 300 lb (136 kg)