JLG LSS Scissors - Manual (Page 57)

SECTION 6 - SERVICE - (RS)
3124288 – JLG Lift – 6-5
6.5 LSS COMPONENT REMOVAL/
INSTALLATION (RS)
Pressure Transducer Removal (RS)
(See Figure 6-1. and Figure 6-2.)
Use the following procedure to safely remove and repair
the pressure transducers on the lift cylinder.
1. Ensure that the key switch is set to ground mode.
2. Engage lift up from the ground panel until the plat-
form has elevated high enough to engage the lift cyl-
inder safety prop.
3. Engage the platform safety prop.
4. Lower the platform on to the safety prop and con-
tinue to engage lift down for 1 second after the plat-
form makes contact with the safety prop.
5. Disconnect power at the batteries.
6. Carefully disconnect the electrical connectors on
each sensor.
7. Remove each pressure transducer.
Pressure Transducer Installation (RS)
1. Insert new pressure transducer and tighten.
2. Reconnect each pressure transducers electrical
connector.
3. Reconnect power at the batteries.
4. Turn machine on and engage lift up from the ground
panel so that the safety prop can be disengaged.
5. Lower the platform to the stowed position.
6. This completes pressure transducer repair.
Figure 6-1. LSS Pressure Transducer Location -
1932RS/6RS
1. Ports On Barrel of Cylinder
2. Pressure Transducers 3. Harness Connectors
Figure 6-2. LSS Pressure Transducer Location -
3248RS/10RS
1. Ports On Bottom of Cylinder
2. Pressure Transducers 3. Harness Connectors
1
2
3
1
2
3