JLG 510AJ Series II Operator Manual - Manual (Page 33)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121292 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: All machines are equipped with control panels that use
symbols to indicate control functions. On ANSI machines
refer to decal located on the control box guard in front of
the control box or by the ground controls for these sym-
bols and the corresponding functions.
NOTE: The indicator panels use different shaped symbols to alert
the operator to different types of operational situations
that could arise. The meaning of those symbols are
explained below.
Indicates a potentially hazardous situation, which if not
corrected, could result in serious injury or death. This
indicator will be red.
Indicates an abnormal operating condition, which if not
corrected, may result in machine interruption or damage.
This indicator will be yellow.
Indicates important information regarding the operating
condition, i.e. procedures essential for safe operation.
This indicator will be green with the exception of the
capacity indicator which will be green or yellow depend-
ing upon platform position.