JLG 510AJ Series II Operator Manual - Manual (Page 54)

SECTION 4 - MACHINE OPERATION
4-6 – JLG Lift – 3121292
DO NOT DRIVE WITH BOOM ABOVE HORIZONTAL EXCEPT ON A
SMOOTH, FIRM AND LEVEL SURFACE.
TO AVOID LOSS OF TRAVEL CONTROL OR “TIP OVER”, DO NOT DRIVE
MACHINE ON GRADES EXCEEDING THOSE SPECIFIED ON THE SERIAL
NUMBER TAG OR AS NOTED IN THE OPERATORS MANUAL.
DO NOT DRIVE ON SIDESLOPES WHICH EXCEED 5 DEGREES (ANSI
MARKETS) OR 4 DEGREES (CE & AUSTRALIA MARKETS).
USE EXTREME CAUTION WHEN DRIVING IN REVERSE AND AT ALL
TIMES WHEN THE PLATFORM IS ELEVATED ESPECIALLY WHEN DRIV-
ING WITH ANY PART OF MACHINE WITHIN 6 FEET (2 M) OF AN
OBSTRUCTION.
TRAVEL GRADES WITH DRIVE SPEED/TORQUE SELECT SWITCH IN
THE FORWARD POSITION.
BEFORE DRIVING, LOCATE THE BLACK/WHITE ORIENTATION ARROWS
ON BOTH THE CHASSIS AND THE PLATFORM CONTROLS. MOVE THE
DRIVE CONTROLS IN A DIRECTION MATCHING THE DIRECTIONAL
ARROWS.
Traveling Forward and Reverse
1. With the engine running, activate footswitch.
2. Position Drive controller to FORWARD or REVERSE as
desired.
This machine is equipped with a Drive Orientation Indicator.
The yellow light on the platform control console indicates
that the boom is swung beyond the rear drive tires and the
machine may Drive/Steer in the opposite direction from the
movement of the controls. If the indicator is illuminated,
operate the Drive function in the following manner:
1. Match the black and white direction arrows on both plat-
form control panel and the chassis to determine the
direction the machine will travel.
2. Push and release the Drive Orientation Override switch.
Within 3 seconds, slowly move the Drive control toward
the arrow matching the intended direction of machine
travel. The indicator light will flash during the 3 second
interval until the drive function is selected.