JLG 510AJ Series II Operator Manual - Manual (Page 34)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-2 – JLG Lift – 3121292
TO AVOID SERIOUS INJURY, DO NOT OPERATE MACHINE IF ANY CON-
TROL LEVERS OR TOGGLE SWITCHES CONTROLLING PLATFORM
MOVEMENT DO NOT RETURN TO THE OFF POSITION WHEN RELEASED.
Ground Control Station
NOTE:Function Enable switch must be held
down in order to operate Telescope, Swing,
Tower Lift, Main Lift, Jib Lift, Platform Level
Override, and Platform Rotate functions.
DO NOT OPERATE FROM GROUND CONTROL STATION WITH PERSON-
NEL IN THE PLATFORM EXCEPT IN AN EMERGENCY.
PERFORM AS MANY PRE-OPERATIONAL CHECK AND INSPECTIONS
FROM GROUND CONTROLS AS POSSIBLE.
1. Platform Rotate
A three position switch controls rotation
of the platform.
ONLY USE THE PLATFORM LEVELING FUNCTION FOR SLIGHT LEVEL-
ING OF THE PLATFORM. INCORRECT USE COULD CAUSE THE LOAD/
OCCUPANTS TO SHIFT OR FALL. FAILURE TO DO SO COULD RESULT IN
DEATH OR SERIOUS INJURY.
2. Platform Leveling
A three position switch allows the opera-
tor to adjust the automatic self leveling
system. This switch is used to adjust the
platform level in situations such as
ascending/descending a grade.
3. Jib Lift (If Equipped)
This switch provides raising and lower-
ing of the jib.