JLG 740AJ ANSI Operator Manual - Manual (Page 34)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-8 – JLG Lift – 3121650
13. Fuel Tank - See Inspection Note.
14. Swing Drive Motor and Brake - See Inspection Note.
15. Door and Latches - Hood door and latches in working con-
dition, properly secured, no loose or missing parts.
16. Tie Rod and Steering Linkage - See Inspection Note.
17. Dual Capacity and Horizontal Cutout Limit Switches if
equipped - Properly secured, no damage to the switches,
arm free to move, and free from dirt and grease.
18. Battery - Proper electrolyte levels; cables tight, no visible
damage or corrosion.
19. Hydraulic Pumps - See Inspection Note.
20. Tower Boom - No visible damage; wear pads secure. All cyl-
inders - rod end pins and barrel-end pins properly secured.
21. Frame - See Inspection Note.
22. Main Boom Sections - No visible damage; wear pads
secure. All cylinders - rod end shafts and barrel-end shafts
properly secured.
23. Upright - In vertical position, relative to the chassis. Refer to
Figure 2-5. and Figure 2-6. If out of alignment, do not use
machine until the upright has been synchronized in accor-
dance with Section 4.16.
Figure 2-4. Daily Walk-Around Inspection (Sheet 3 of 3)