1 introduction, 2 operating specifications, Introduction -1 – JLG 740AJ ANSI Operator Manual User Manual
Page 97: Operating specifications -1
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121650
– JLG Lift –
6-1
SECTION 6. GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6.1
INTRODUCTION
This section of the manual provides additional necessary infor-
mation to the operator for proper operation and maintenance of
this machine.
The maintenance portion of this section is intended as informa-
tion to assist the machine operator to perform daily maintenance
tasks only, and does not replace the more thorough Preventive
Maintenance and Inspection Schedule included in the Service
and Maintenance Manual.
Other Publications Available:
Service and Maintenance Manual .............................................3121651
Illustrated Parts Manual - Global................................................3121652
6.2
OPERATING SPECIFICATIONS
Table 6-1. Operating Specifications
Maximum Work Load (Capacity)
ANSI Unrestricted:
CE/AUS Unrestricted:
500 lb (227 kg)
500 lb (230 kg)
Maximum Travel Grade
with boom in stowed position
(Gradeability) 4WD Figure 4-4.
45%
Maximum Travel Grade
with boom in stowed position
(Side Slope)Figure 4-4.
5° ANSI
3° CE/AUS
Maximum Vertical Platform Height:
74 ft. (22.5 m)
Maximum Horizontal Platform Reach
51 ft. 10 in. (15.8 m)
Ground Clearance
12 in. (30 cm)
Wheelbase
10 ft. (3.05 m)
Maximum Tire Load:
17,755 lbs. (8060 kg)
Maximum Drive Speed:
3.0 mph (4.8 kph)
Maximum Hyd. Operating Pressure
4500 psi (310 Bar)
Electrical System Voltage
12 volts
Jet Blast Rating
90 mph (145 kph)