IOGear GWPAP1 - Manual (Page 10)

10
1. Make sure the NetShair_Nano_XXXX Wi-Fi Network
is connected.
2. After setting the NetShair Nano in Router Mode (see Router
Mode Setting), tap on
Advance Setting and then select
Set WAN Interface.
3. Select PPPoE from the menu and enter
username and password.
4. Tap OK, then Restart when
prompted. Wait approximately 60
seconds for the NetShair Nano to restart.
5. Once restarted, connect Ethernet cable
to Netshair Nano.
6. Connect back to NetShair_Nano_XXXX Wi-Fi Network.
Open your web browser to access the internet.
Router Mode: PPPoE
NetShair Nano comes preset for DHCP Mode which is the
standard mode for cable internet providers. When using NetShair
Nano with a DSL Modem please follow the steps below: