IOGear GWPAP1 User Manual
Page 16
Advertising
16
1. Make sure the NetShair_Nano_XXXX
Wi-Fi Network is connected.
2. After setting the NetShair Nano in
Router Mode (see Router Mode
Setting), tap on
Advance Setting
and then select
Set WAN Interface.
3. Select
PPPoE from the menu and
enter username and password.
4. Tap
OK, then Restart when
prompted. Wait approximately
60 seconds for the NetShair
Nano to restart.
5. Once restarted, connect Ethernet cable to Netshair Nano.
6. Connect back to NetShair_Nano_XXXX Wi-Fi Network. Open
your web browser to access the internet.
Router Mode: PPPoE
NetShair Nano comes preset for DHCP Mode which is the
standard mode for cable internet providers. When using NetShair
Nano with a DSL Modem please follow the steps below:
Advertising